Compx-elock Network Fridge Manuel d'utilisateur télécharger pdf (Page 12)

Installing the VERTICAL mount refrigerator kit

Mount the strike

at least 4" from

NON-HINGED EDGE

of the refrigerator.

There are two main parts of this installation: installing the strike and installing

the eLock assembly. The strike and the eLock assembly can be mounted either

with foam tape or by drilling holes and using screws. It is important to note that

mounting the strike and the eLock assembly are independent of each other. One

can be foam tape mounted, and one can be drill mounted if desired. The two do

not need to be mounted using the same method.

• verify eLock operation before beginning instaLLation •

a. Screw one tamper resistant sheet metal

screw into the center of the strike's slotted

area. Note: The end of the metal strike

needs to curve up.

b. Place the plastic strike cover over the

metal strike. If strike was mounted using

foam tape, please proceed to Step 3.

c. Attach with one tamper resistant machine

screw.

Install the strike

Step

Secure the strike and attach the strike cover (if strike was mounted using foam tape, ONLY do b.)

Step

Foam Tape Installation: Option A

Please note that if foam tape installation

of the strike is used, the strike will not

be adjustable once it's put in place.

a. Clean the top refrigerator as well as the

strike with rubbing alcohol. Wait for the

alcohol to dry.

b. With a pencil, mark refrigerator 6-7/8"

from the front of the door and at least 4"

from the non-hinged edge.

Measure from this line to the front of the

cabinet (dim. “A”); cut a piece of tape

this length.

c. Remove tape backer and afﬁx to end

of strike. The upward curve should be

on top. Apply tape to the opposite side.

Remove backer. Line up strike with line on

refrigerator; apply pressure to seal it on.

Note: The end of the metal

strike needs to curve up.

Option B

Option A

Drilling Installation: Option B

a. Before drilling, verify that there are no

refrigerant lines inside the top of the

refrigerator.

b. Drill a 9/64” hole, 5-7/8” from the

edge of the front of the refrigerator and

at least 4” from the non-hinged edge of

the refrigerator.

1 2 ... 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Compx-elock Network Fridge Manuel d'utilisateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Sécurité Compx-elock Network Fridge